Hello FreeSufers,

I ran several analyses in qdec, and now have problem visualize previous analyses results...which sounds dumb... Please let me know if you have any ideas. 

I used fsaverage. I found this page http://freesurfer.net/fswiki/FsTutorial/Visualization using tksurfer, but it needs to do the "make_average". And it mentioned some "pre-computed results", I thought which would be the results of analyses via command line. Does this apply to the results by qdec? 

I also found the following command using Freeview: 

freeview -f SUBJECTS_DIR/fsaverage/surf/lh.inflated:annot=aparc.annot:annot_outline=1:overlay=lh.gender_age.glmdir/lh-Avg-thickness-age-Cor/sig.mgh:overlay_threshold=4,5 -viewport 3d

But I don't know which part of the command should I change. I tried the command as it is above anyway and the error is: Unrecognized sub-option flag 'annot_outline'

Many thanks! All the best,

Qijing

_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer


The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.