On 22 May 2017 at 07:39, Ramesh Babu <mgrameshbabu2013@gmail.com> wrote:

> The following last line get repeated same way except (%) in the second line
> pasted below. On the third line "Did not call MRIsetResolution", is it error
> or normal process? Since repeated many times I thought there is some error.
>
> PutOnGPU: Did not reset gca in dst
> 0270: dt=9.072001, rms=0.557 (0.021%), neg=0, invalid=762
> LabelTerm: Did not call MRIsetResolution

That's completely normal - it was sort of an aide-memoire for myself.
Should things start messing up in interesting ways, that might be
something to go and check (at the time I did the port, it was a no-op
for the command I was running). So long as the
nnn: dt=....
lines are popping out OK, it's running.

Richard
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer


The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.