the easiest thing would be to copy it into surface as lh.bem then run tksurfer on it

On Thu, 1 Nov 2012, octavian lie wrote:

Thank you for your quick prompt, how do I pull the inner skull surface into tksurfer, given it is in /bem and not in /surf, and
does not have a lh or rh option?
Octavian

On Thu, Nov 1, 2012 at 11:41 AM, Bruce Fischl <fischl@nmr.mgh.harvard.edu> wrote:
      Hi Octavian

      sure, define a sagittal cutting plane in tksurfer, or in matlab set ripflag=1 for all vertices with the x coord > 0
      (or < 0)

      cheers
      Bruce
      On Thu, 1 Nov 2012, octavian lie wrote:

            Dear all,
             
            Is there a way to crop a surface in FS, freeview or matlab? I have the inner_skull_surface in BEM
            folder, and I want to see just
            the right half, akin to cropping along the A (RAS) axis from the left. This is in order to visualize the
            inside of the surface
            with some electrode applications. Also, if the surface can be created in MNE just on the right side that
            will solve it.
            Help much appreciated,
            Octavian Lie.




The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.