Hi Nazanin,

To change color you will need to modify the look up table, i.e., load your own look up table. There is no way to only display a few selected labels. As a workaround, you may try applying a look up table with only a few labels in it.

Best,
Ruopeng

> On Feb 21, 2017, at 5:20 AM, N Saf <nalives@gmail.com> wrote:
>
> Dear Experts,
>
> I load the T1 and aseg file in freeveiw and select the lookup table ,and show as isosurface in 3D view for a label .Is it possible to change the color(for example label 13 is blue but I want to show it as yellow!).another question is that if I want to show multiple labels which are not in the range how should I do it ? for example I want to see labels 11 & 13 & 30  but not the lables between ,how can I do it?thanks for your support.
>
>
> Best Regards,
> Nazanin

> _______________________________________________
> Freesurfer mailing list
> Freesurfer@nmr.mgh.harvard.edu
> https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer


_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer


The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.