Hi Matthieu - In 5.1 the number of control points (ncpts) was only one number, the same for all 18 tracts. Not sure if this is what's causing the error.

a.y

On Wed, 11 Dec 2013, Matthieu Vanhoutte wrote:

Hi Anastasia,
I have taken this original file in "FSDIR5.1/bin/dmrirc.example" and modify
into "dmrirc.tutorial", so this is meant for use with the version of tracula
that's in 5.1 ?

I will switch to the last version, but before this I'd like to succeed
launching tracula on 5.1...

Best,

Matthieu


2013/12/11 Anastasia Yendiki <ayendiki@nmr.mgh.harvard.edu>

      Hi Matthieu - This sample dmrirc file is meant for use with the
      version of tracula that's in 5.3, not 5.1. I would strongly
      recommend switching to that version of tracula anyway, due to
      improvements in performance and speed.

      a.y

      On Wed, 11 Dec 2013, Matthieu Vanhoutte wrote:

            Hello experts,

            I am running the first pre-processing
            step in Tracula on FS 5.1 and come across the
            error: 

            set: Variable name must begin with a
            letter

            I have attached my dmrirc file. Did I make a mistake
            in this file?
            Best regards,

            Matthieu





The information in this e-mail is intended only for the person to whom
it is
addressed. If you believe this e-mail was sent to you in error and the
e-mail
contains patient information, please contact the Partners Compliance
HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you
in error
but does not contain patient information, please contact the sender
and properly
dispose of the e-mail.