Hi Doug, Thanks for the reply. Yeah I have my
qdec.table.dat file in the same format as wiki says and in tab delimited
format. But when I try to run fReadQdec it reads it as
N(# of subjects)X1 cell (discounting for all tabs and spaces). I was
assuming it would give me N X M(no of columns for each variable that I
put in table).
-Sabin
On Tuesday, February 18, 2014 1:26 PM, Douglas N Greve <greve@nmr.mgh.harvard.edu> wrote:
yes, it has a certain format. Look at the examples on the wiki doug
On 02/18/2014 11:19 AM, sabin khadka wrote: > Hi all, > I am trying to run fReadQdec.m. My qdec.table.dat file is a tab > delimited file. However when it reads to
Qdec variable it reads it as > N(# of subjects)X1 cell (discounting for all tabs and spaces). I tried > debugging the code but it seems to me like it is just a simple read > file in matlab. Does the qdec.table.dat file need to be in certain format? > > -Sabin
The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.