Hi Trisanna,

There is no straight-forward way to let you edit surface labels but you can try these steps:

1. Load a volume and a surface.

2. Load the label you want to edit as volume label (ROI).

3. Select the ROI in the layer list to bring up ROI property panel. Click on “Map to Surface” dropdown box and select the surface. You should see the label shown on the surface.

4. Switch to ROI Edit mode. You can start to edit the label on the surface. Click left mouse button to add vertex. Shift+Left button to remove vertex.

5. After edit, you might notice direct save button is still grayed out, which is a bug. But you can save it by “Save ROI as”. Sorry for the inconveneince.

In future update we plan to simply label editing by combining surface and volume labels. Hopefully that will make label editing a lot easier.

Best,

Ruopeng

On Jan 25, 2017, at 11:48 AM, Trisanna Sprung-Much <trisanna.sprung-much@mail.mcgill.ca> wrote:

Hi there

Does the 6.0 version of Freeview have a way to edit labels on surfaces similar to how tksurfer allowed us to do this?

Thanks!

Trisanna

--

Ph.D. Candidate

McGill University

Integrated Program in Neuroscience

Psychology

_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer

_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer


The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.