The same one; just change the input file and the analysis ID

- T2:       recon-all -s mySubject -hippocampal-subfields-T1T2 myT2scan.nii.gz  T2

- FLAIR: recon-all -s mySubject -hippocampal-subfields-T1T2 myFLAIRscan.nii.gz  FLAIR

Cheers,

/Eugenio

Juan Eugenio Iglesias

Senior Research Fellow
Translational Imaging Group
University College London
http://www.jeiglesias.com
http://cmictig.cs.ucl.ac.uk/

On 5 Sep 2016, at 15:10, Vaz pandolfo, Renata <rvp8@njit.edu> wrote:

Dear FS experts,

I have a question about the "segmentation with an additional scan - multispectral segmentation" 
on the hippocampal sf segmentation, FS dev. 6.0.

For controls on which I had already run recon-all -all, I added the T2 sequence with the following 
command:

recon-all -s <subject_name> \
-hippocampal-subfields-T1T2 <file name of additional scan> <analysisID>

Now, if I want to do the same thing with FLAIR as the additional input, which flag should I use?

Thank you,

Renata

_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer


The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.