In this way, I see the cortical thickness' value near the "curvature" indication, voxel-by-voxel. It's ok?
And, when I write the command line in tkmedit: "tkmedit SUBJECT_ID brainmask.mgz -surfs", I see the brainmask image and two colored line, a red one and a green one. The first one is th edge of cortical surface; the other one is the white and grey matter's edge. Between these 2 lines, the software calculates the cortical thickness.
Is this ok?Have I understood well?
Thanks.

--- Sab 12/3/11, Bruce Fischl <fischl@nmr.mgh.harvard.edu> ha scritto:

Da: Bruce Fischl <fischl@nmr.mgh.harvard.edu>
Oggetto: Re: [Freesurfer] (no subject)
A: "Angela Cosentino" <hamtaro88@hotmail.it>
Cc: freesurfer@nmr.mgh.harvard.edu
Data: Sabato 12 marzo 2011, 22:06

you can load the lh.thickness (if you are viewing the left hemisphere
surface) or rh.thickness (if you are viewing the right hemisphere surface)
in tksurfer either using file->load curvature or file->load overlay

cheers
Bruce

On Sat, 12 Mar 2011, Angela Cosentino
wrote:

>
> Hi!
> How can I view the cortical thickness' misure?
>
>
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer


The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.