Hi Claudia

that defect is bigger than more cortical surfaces so something is dramatically wrong. Did you check any of the outputs (wm.mgz, filled.mgz, lh.orig, etc...)?

cheers
Bruce

On Thu, 18 Apr 2013, Claudia Dacquino wrote:

Hi freesurfer, 
my autorecon2-cp after ctrl pts edits exited with this error message: 

CORRECTING DEFECT 0 (vertices=176788, convex hull=8149)
Excessive topologic defect encountered: could not allocate -776253752 edges for retessellation
Cannot allocate memory

Could anyone help me with this, please?

Thanks to all.

Cheers
Claudia

The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.