Thanks bruce for your response. Since there is no documentation, how can i use it because I seen trends on the forum where it was suggested to use reposition surface ( e.g. https://mail.nmr.mgh.harvard.edu/pipermail/freesurfer/2012-October/026117.html). Use = directions and parameters to input. Thanks

Best,

Paul

On Tue, Jan 10, 2017 at 12:42 PM, Bruce Fischl <fischl@nmr.mgh.harvard.edu> wrote:

Hi Paul

sorry, this is something that Ruopeng put together for me to mess around with - there isn't any documentation

cheers
Bruce

On Tue, 10 Jan 2017, miracle ozzoude wrote:

Hello Freesurfer, I would like to learn how to use the reposition surface
tool in freeview. Specifically, what parameters to enter in the gui (see
screenshots). Is there any documentation on how to use it if not, can
someone with experience work me through it. Thank you.
best,
Paul

_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer

The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.