dmri_motion --dwi yourDWIs.nii.gz --mat your.ecclog --bval your.bvals --out output.txt
as well as trac-all -qa -c dmrirc_file with location of bval specified and trac-all -prep -c, respectively
Then it's no surprise that the error doesn't occur in 5.2, because 5.2 doesn't run dmri_motion at all.
When you run dmri_motion on the command line, do you use the same syntax as the one you're showing below?
On Thu, 20 Feb 2014, Gerit Pfuhl wrote:
yes,
it happens at trac-all -qa after loading the *.nii file (see attachment) or when run as
dmri_motion --dwi dwi_orig.nii.gz --mat dwi.ecclog --bval dmri/bvals --out dwi_motion.txt immediately.
On 20 February 2014 17:08, Anastasia Yendiki <ayendiki@nmr.mgh.harvard.edu> wrote:
Does the error in trac-all -prep with 5.3 occur when dmri_motion is run or at a different step?
On Thu, 20 Feb 2014, Gerit Pfuhl wrote:
Dear Tracula Experts,
after careful checking we still cannot run trac-all -qa or dwri-motion as the command
always returns: could not
open bvals but the same file is flawlessy opened/retrieved in version 5.2.
[cat bvals is fine, trac-all -prep in 5.2. runs fine, trac-all -prep in 5.3 returns could
not open bvals]
Kind regards
Gerit Pfuhl
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.