Dear Freesurfer experts,
I uploaded a .nii.gz file (which can be downloaded from 'http://gate.nmr.mgh.harvard.edu/filedrop2/?p=7pbsgklemux'). I hope you would be willing to comment on the quality of this scan for use with Freesurfer (you can find some parameters below; the scan was
acquired on a 3T Philips scanner). Running it through recon-all seems to give nice results, but then again, I am in a phase of running pilots before the start of a new study, and I do not have much experience with Freesurfer results yet.
coil: 32 channel
Sequence: T1w_TFE_3D
TFE factor: 256
Acquisition time: 10:14
FoV FH256xAP256xRL160 mm
160 sagittal slices
fold-over direction AP
fat shift direction F
scan mode 3D
acquisition matrix 256 x 256
acquisition voxel size 1.00/1.00/1.00
reconstructed voxel size 1.00/1.00/1.00
TR shortest (=7.6ms)
TE shortest (=3.5ms)
RF: flip angle 8 degrees
Acceleration: no SENSE
inversion-prepared, inversion delay time: shortest
Cheers,
Jelmer Kok
De inhoud van dit bericht is vertrouwelijk en alleen bestemd voor de geadresseerde(n). Anderen dan de geadresseerde(n) mogen geen gebruik maken van dit bericht, het niet openbaar maken of op enige wijze verspreiden of vermenigvuldigen. Het UMCG kan niet aansprakelijk
gesteld worden voor een incomplete aankomst of vertraging van dit verzonden bericht.
The contents of this message are confidential and only intended for the eyes of the addressee(s). Others than the addressee(s) are not allowed to use this message, to make it public or to distribute or multiply this message in any way. The UMCG cannot be held
responsible for incomplete reception or delay of this transferred message.