Hi Mark

does the input to mri_ca_normalize look ok (the nu.mgz)? Is the talairach.xfm ok?

Bruce

On Thu, 16 Jan 2014, Mark Plantz wrote:

Hello freesurfers,

     I am running into a problem during the "CA Normalize" sequence of
autorecon-2. It looks like freesurfer is having a hard time creating control
points based off the atlas I am using. The output is as follows:

"finding control points in <Left_Cerebral_White_Matter>...found  0 control
points"

      This repeated for the other various regions included in the atlas. The
only control points found were "168 control points" in the
"Right_Cerebral_White_Matter". Could this possibly be an alignment issue? If
so, is there an easy way to check the alignment?

Thank you,


Mark

The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.