We have same problem. Any advise would be great appreciated.

 

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Sumiko Abe, Ph.D
Dept. of Psychiatry & Human Behavior
University of California, Irvine
5251 California Dr, #204
Irvine, CA 92697

Tel: 1-949-824-2972
E-mail: sumikoa@uci.edu

 

From: freesurfer-bounces@nmr.mgh.harvard.edu [mailto:freesurfer-bounces@nmr.mgh.harvard.edu] On Behalf Of Ahmed, F, Me <fahmed@sun.ac.za>
Sent: Wednesday, September 30, 2009 1:31 AM
To: Freesurfer Mailing List
Subject: [Freesurfer] tksurfer

 

Hello,

 

I’m trying to view and check the smoothing and inflation surfaces, the white and pial surfaces for “bert” using tksurfer as I’m trying to get used to using Freesurfer, but I’m a little confused to what I’m seeing. When I type in: “tksurfer bert lh inflated” for example, I only see a very small section at the very end of the image…is this correct? When I view the curv files, I do see a green pattern overlaid on the inflated surface, however it’s still so small. When I view the pial and white surfaces, again, the section displayed is very small, I don’t know if this is correct or if this is what I am supposed to be seeing? Also, when I type in: “tksurfer bert lh sphere”, I see nothing at all.

 

If someone could shed some light on the matter I’d be extremely grateful.

 

Thank you

 

 

 

 


This message contains confidential information and is intended only for the individual named. If you are not the named addressee you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately by e-mail if you have received this e-mail by mistake and delete this e-mail from your system. E-mail transmission cannot be guaranteed to be secure or error-free as information could be intercepted, corrupted, lost, destroyed, arrive late or incomplete, or contain viruses. The sender therefore does not accept liability for any errors or omissions in the contents of this message, which arise as a result of e-mail transmission.