---------- Forwarded message ----------
From: Yunxin Wang <yunxinwang@gmail.com>
Date: 2013/8/6
Subject: Re: [Freesurfer] How to transfer a reconstructed pial surface file into a 256*256*256 matlab matrix file?
To: Bruce Fischl <fischl@nmr.mgh.harvard.edu>

Hi Bruce,

Thanks for your response. Actually I want to use the fast marching toolbox to further analyze the pial surface that FreeSurfer has reconstructed automatically, but according to the procedure only the pial surface will be used for fast marching process and I found out the input file of fast marching is a 256*256*256 matlab file which I could just load in matlab but couldn't see any detail. Do you think I can use the freesurfer_read_surf function in matlab to transfer the surface?

Best,

Yunxin

2013/8/5 Bruce Fischl <fischl@nmr.mgh.harvard.edu>

Hi Yunxin

the surface lives in a continuum and is 2D. Do you mean filling the space between the ?h.white and ?h.pial surfaces? We do that as part of recon-all and create ribbon volumes in the mri dir
cheers
Bruce

On Mon, 5 Aug 2013, Yunxin Wang wrote:

Hi dear all,
I'm new here and I've a simple question that how could I transfer the reconstructed pial surface file(like lh.pial) into a
256*256*256 matlab matrix used in later fast marching process?

Any suggestion will be appreciated!
Thank guys.

Best,
Yunxin Wang

The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.