Hello again mailing list,

Can anyone address the possible cause of the medial surface problem shown below (overestimating of rh medial surface, shows up in the long image and not the tp or base images). Forgot to mention that I am using freesurfer v5.3 with an updated mris_make_surfaces binary (sourced from the development version at ftp://surfer.nmr.mgh.harvard.edu//pub/dist/freesurfer/dev_binaries/centos6_x86_64/ ).

Here is the image again:

unknown.png

Kind regards,

Bronwyn Overs
Research Assistant

Neuroscience Research Australia
Margarete Ainsworth Building
Barker Street Randwick Sydney NSW 2031 Australia
M 0411 308 769 T +61 2 9399 1883 F +61 2 9399 1265


On 6 Mar 2017, at 1:17 pm, Bronwyn Overs <b.overs@neura.edu.au> wrote:

Hi mailing list,

I am currently processing a longitudinal image and have come across a problem at the medial surface in the long image (step 3). As you can see in the attached image, the rh medial surface has been significantly overestimated and extends into the lh surface. This error showed up only in only 1 of the 2 long images for this subject, and both the time-point images and the base are perfectly fine. Do you know why this is happening? 

<Screen Shot 2017-03-06 at 1.09.53 pm.png>


Kind regards,

Bronwyn Overs
Research Assistant

Neuroscience Research Australia
Margarete Ainsworth Building
Barker Street Randwick Sydney NSW 2031 Australia
M 0411 308 769 T +61 2 9399 1883 F +61 2 9399 1265


_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer


The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.