Hi

do you mean in the curvature display? If so, it is the "0" point at which
red transitions to green (for positive and negative curvature)

cheers
Bruce
On Thu, 13
Jul 2017, Trisanna Sprung-Much wrote:

> Hi there
> I have a question concerning viewing a surface in Freeview (FS 6.0): What
> does the "mid point" variable refer to? I can change it and it seems to
> change the shading within the sulci when I am looking at a white matter
> surface.
>
> Many thanks
>
> Trisanna
> --
> Ph.D. CandidateMcGill University
> Integrated Program in Neuroscience
> Psychology
>
>
>
>
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer


The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.