[Homer-users] Homer and ETG-4000

[Ahmad CHADDAD]

Hi ,

yeah , you can open these files by MATLAB , function is load ('.csv').

thank
Ahmad

Selon Marco Montalto <montaltomarco at onvol.net>:

> I have collected data from an ETG-4000 and exported it in "Integral Mode" as
> a csv file. I now have three files per subject, one for HbO, one for Hb and
> one for Total Hb. Does anyone know whether this type of data can be used with
> Homer or whether I should have exported my data in "Measurement Mode"? Any
> advise would be greatly appreciated. Thanks.
> _______________________________________________
> Homer-users mailing list
> Homer-users at nmr.mgh.harvard.edu
> https://mail.nmr.mgh.harvard.edu/mailman/listinfo/homer-users
>
>
> The information in this e-mail is intended only for the person to whom it is
> addressed. If you believe this e-mail was sent to you in error and the e-mail
> contains patient information, please contact the Partners Compliance HelpLine
> at
> http://www.partners.org/complianceline . If the e-mail was sent to you in
> error
> but does not contain patient information, please contact the sender and
> properly
> dispose of the e-mail.
>
>


..........................................................
Ahmad CHADDAD
Doctorant à l'Ecole Polytechnique de Montréal.
Laboratoire de Neurotechnologies Polystim.
Ecole Polytechnique de Montreal, Dépt de génie électrique.
Salle / Room M5306, Pavillon Lassonde / Lassonde Building,
Tel.(514) 340.4711-X7838
http://www.polystim.ca
...........................................................