[Mne_analysis] Concatenate epochs

[Claire Braboszcz]

Hi Dirk, 

I think this can happen if you have different numbers of channels between the two datasets you are trying to concatenate. You need to make sure that any channel removed during preprocessing in dataset 1 is also removed from dataset 2.

Hope this helps, 
Claire


Dirk van Moorselaar – Fri., 14. July 2017 11:29
> Dear all,
> 
> I am currently analysing an experiment where I collected data in two separate sessions. After preprocessing I try to concatenate the epochs from separate sessions into a single epoch. However, this fails in some cases due to an assertion error. I have the feeling this is because some subjects did a different nr of blocks in session 2 than in session 1 (or vice versa). Is this a problem and if so is there another way to concatenate epochs?
> 
> Thanks again for your help,
> 
> Dirk van Moorselaar
> 
> 
> 
> 
> 
> _______________________________________________
> Mne_analysis mailing list
> Mne_analysis at nmr.mgh.harvard.edu
> mail.nmr.mgh.harvard.edu/mailman/listinfo/mne_analysis
> 
> 
> The information in this e-mail is intended only for the person to whom it is
> addressed. If you believe this e-mail was sent to you in error and the e-mail
> contains patient information, please contact the Partners Compliance HelpLine at
> www.partners.org/complianceline . If the e-mail was sent to you in error
> but does not contain patient information, please contact the sender and properly
> dispose of the e-mail.