Thank you Douglas! mri_coreg did an awesome job and the registration look good.

On Mon, Feb 22, 2016 at 7:51 PM, Douglas Greve greve@nmr.mgh.harvard.edu wrote:

If you have spm, you can use --init-spm. Alternatively, you can use mri_coreg instead of bbr (bbr is not as effective on blurry data)

ftp://surfer.nmr.mgh.harvard.edu/transfer/outgoing/flat/greve/mri_coreg

mri_coreg --s $fs --mov ${pet_ext}_LIA.nii --lta output.lta

Also, why is the top of the head cut off? That makes it much more difficult to register.

doug

On 2/22/16 8:02 PM, Pradeep wrote:

Hello All,

I am trying to map pet scans to MRI using bbregister and quite a few subjects were improperly registered.

Here are my steps: bbregister --s $fs --mov ${pet_ext}_LIA.nii --init-fsl --t1 --lta output.lta tkregister2 --mov summed_LIA.nii --reg output.dat --surf

[ mri]$ more output.dat.mincost 0.860663 0.000513 0.000492 -11.863233 The first value is quite close to 1 so its bad

I have attached a screen shot of the image and the log file generated after bbregister. Please let me know if there are any parameters that I could tweak to make the registration better.

Thank you for your help, -Pradeep

---

Freesurfer mailing listFreesurfer@nmr.mgh.harvard.eduhttps://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer

---

Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer

The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.