Thank you Doug. 4.2 uses *-t* instead of *--tablefile. *I need to update to 5.0.

Jesse

On Mon, Jan 24, 2011 at 3:34 PM, Douglas N Greve greve@nmr.mgh.harvard.eduwrote:

I think version 4.2 used a different command-line than 4.5 and higher. Check it with --help.

doug

Jesse Bledsoe wrote:

...

Hi FreeSurfer team,

After running:

asegstats2table --subjects /subject1 subject2... /--meas volume --tablefile aseg.stats.txt

I receive the following error:

ERROR: flag --tablefile not recognized

Stamp: freesurfer-Linuxcentos4-stable-pub-v4.2.0

Any suggestions are greatly appreciated,

Jesse

---

---

Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer

-- Douglas N. Greve, Ph.D. MGH-NMR Center greve@nmr.mgh.harvard.edu Phone Number: 617-724-2358 Fax: 617-726-7422

Bugs: surfer.nmr.mgh.harvard.edu/fswiki/BugReporting FileDrop: www.nmr.mgh.harvard.edu/facility/filedrop/index.html

The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.