yes, that will prevent it I believe. Or you can load them in freeview from the interface (I believe they are a type of pointset in freeview) On Thu, 27 Oct 2011, Matt Glasser wrote:

Hi Bruce,

That didn't happen, but perhaps because I loaded the volume with -f instead of the more standard way. I'll try it again.

Thanks,

Matt.

-----Original Message----- From: Bruce Fischl [mailto:fischl@nmr.mgh.harvard.edu] Sent: Thursday, October 27, 2011 12:53 PM To: Matt Glasser Cc: freesurfer@nmr.mgh.harvard.edu Subject: Re: [Freesurfer] Viewing Control Points

Hi Matt

they will be loaded by default in tkmedit when you load any volume if the file subject/tmp/control.dat exists.

cheers Bruce On Thu, 27 Oct 2011, Matt Glasser wrote:

...

Hi,

Is it possible to view control points (in control.dat), that you already created?  If so, how do you do it?

Thanks,

Matt.

The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.