Hi Bruce, in Freeview, I am using the voxel edit tool called "Contour".

Sarah ________________________________________ Van: freesurfer-bounces@nmr.mgh.harvard.edu [freesurfer-bounces@nmr.mgh.harvard.edu] namens Bruce Fischl [fischl@nmr.mgh.harvard.edu] Verzonden: dinsdag 13 mei 2014 17:29 Aan: Freesurfer support list Onderwerp: Re: [Freesurfer] how to save an intensity contour?

Hi Sarah

what tool are you using to draw the contour?

Bruce On Tue, 13 May 2014, Burke, Sarah wrote:

Hello, I am using the intensity contour tool for defining a white/gray matter border of my ROI. I can adjust my ROI according to this contour and save it. However, the contour itself is not saved (to the same layer as the ROI) and will not be loaded when opening the ROI layer again later. Is there a possibility to save the contour (maybe to an extra layer)?

Thank you very much! Sarah

_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer

The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.