Hi Fidel,

The bvecs/bvals files should have 3/1 columns respectively (as opposed to 3/1 rows that yours have). Could you try if transposing the entries in your files help?

Tanja.

On Fri, Feb 17, 2012 at 12:29 PM, Fidel falfaro@hggm.es wrote:

Dear all,

I have tried to execute trac-all and I have found this error in the process (From the log):

...

...

...

...

...

> > > > > >

dtifit -k /X/subjects//S1/dmri/dwi.nii.gz -m /X/subjects//S1/dlabel/diff/aparc+aseg_mask.flt.nii.gz -r /X/subjects//S1/dmri/bvecs -b /X//S1/dmri/bvals -o /X/subjects//S1/dmri/dtifit

Error: data and bvals/bvecs do not contain the same number of entries

...

...

...

...

...

> > > > > >

I have seen in the mailing list that it has happened before, but I have not found the solution.

You can find the bvals and bvecs files attached. As far as I can see, they have the same number of rows, so... What is the problem?

Thanks and best regards,

Fidel.

---

Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer

The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.