Juergen,

I'm pretty sure that message can be ignored. I see it myself in our own -long runs, and I think it results from initializing the tp2 surface with the tp1 surface (which then gets deformed into tp2's volume).

Nick

On Wed, 2008-09-24 at 16:18 +0200, Juergen Haenggi wrote:

Dear FS experts

I run recon-all -long and the following warnings occurred in Smooth2 and Inflation2:

WARNING: the source volume info is not consistent between WARNING: the info contained in the surface data and that of the transform.

Can I ignore this warning?

Thanks in advance Regards Juergen

---

Juergen Haenggi Ph.D. (Dr. des.) Division of Neuropsychology Institute of Psychology University of Zurich Binzmuehlestrasse 14, PO Box 25 8050 Zurich, Switzerland 0041 44 635 73 97 (phone office) 0041 76 445 86 84 (phone mobile) 0041 44 635 74 09 (fax office) BIN 4.D.04 (office room number) j.haenggi@psychologie.uzh.ch (email) http://www.psychologie.uzh.ch/neuropsy/ (website) http://www.juergenhaenggi.ch (private website)

---

---

Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer