Hi Bruce,
As per this paper: https://elifesciences.org/articles/29285#abstract (Figure 1—figure supplement 4), Local GI is ratio of two quantities and as per this http://en.citizendium.org/wiki/Gyrification, GI is also ratio of two quantities.
So both GI and LGI should be 'unitless' as per these papers. But again, e.g. http://www.sciencedirect.com/science/article/pii/S2213158215000856 indicates GI in 'mm'.
Are there any typos or I am misunderstanding something here?
Thanks.
On Fri, Dec 22, 2017 at 8:45 PM, Bruce Fischl fischl@nmr.mgh.harvard.edu wrote:
Are you confusing GI with LGI?
On Dec 22, 2017, at 4:33 PM, Martin Juneja mj70481@gmail.com wrote:
Hi,
I came across several papers e.g. http://www.sciencedirect. com/science/article/pii/S2213158215000856 where gyrification index (GI) is indicated in 'mm'.
By definition GI is the ratio of two quantities: inner contour/outer contour (http://en.citizendium.org/wiki/Gyrification), therefore, shouldn't GI be 'unitless' then?
I am not sure which way is this correct?
Thanks.
Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.