Oh, right. Mehul, you'll need to tell it to fill the ribbon with something like --proj frac 0 1 .1 doug
On 06/26/2013 06:55 PM, Bruce Fischl wrote:
won't the anatomical_stats one multiply thickness by surface area, where the label2vol will only fill voxels on the gray/white boundary, not all the way through the ribbon? Mehul: if you visualize the one from label2vol does it fill the ribbon or just hug the white boundary?
On Wed, 26 Jun 2013, Douglas N Greve wrote:
not necessarily. That is a very small structure, and getting a few edge voxels wrong will mess things up a lot. Can you load lh-new-erc.mgz in tkmedit and load the surfaces too and see how good it did? doug
On 06/26/2013 06:49 PM, Mehul Sampat wrote:
Hi Folks,
I am trying to create an entorhinal cortex volume from ?h.entorhinal_exvivo.label using mri_label2vol
I cd to the subject dir ($SUBJECTS_DIR/bert) and the command I use is:
*mri_label2vol --label label/lh.entorhinal_exvivo.label --temp
mri/nu.mgz --identity --o mri/lh-new-erc.mgz*
I took the sum of the voxels in this new mask i created (lh-new-erc.mgz) and it is 215; I looked at the volume provided inlh.entorhinal_exvivo.stats and it is 925; (from the log file I believe this is created using the command:
mris_anatomical_stats -mgz -f ../stats/lh.entorhinal_exvivo.stats -b -l ./lh.entorhinal_exvivo.label bert lh white)
I was expecting the numbers to match orat-leastbe close; I am guessing I am using mri_label2vol incorrectly ?
Could someone help me with this issue ?
Thanks
Mehul
Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer