Hello Gregory,
The radius of the circular region is 25 mm by default. If you want you can change it, but I will not advise radii below 20 mm or above 30 mm.
Best,
Marie
On May 13, 2013, at 11:44 AM, Gregory Kirk gkirk@wisc.edu wrote:
Hello
Im preparing an LGI(local gyrification index) manuscript and seems i don't know the default radius that is used for the circular region defined on the outer surface that the boundary of is then projected onto the pial surface to get the corresponding pial region ?
hope im clear, not the radius of the closing operator.
thank you
Greg _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.