Dear Bruce,
Thank you very much! Sincerely, Ye
On Tue, Jul 2, 2013 at 4:34 PM, Bruce Fischl fischl@nmr.mgh.harvard.eduwrote:
Hi Ye -autorecon3
should always be run after any of the autorecon2 steps. If it's not on the tutorial, that is a mistake
cheers Bruce
On Tue, 2 Jul 2013, ye tian wrote:
Dear Freesurfers,
I just realize that in the tutorial example of "geometric accuracy", recon-all -autorecon2-wm is used to recreate the final surfaces; while in "lateral ventricle", recon-all -autorecon2-wm -autorecon3 is used. However, the modification steps look the same to me -- fill in the "hole" of white matter in wm.mgz.
Why do they use different commands after all? What's the difference between -autorecon2-wm and -autorecon2-wm -autorecon3?
Thank you very much!
Sincerely, Ye
The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/**compliancelinehttp://www.partners.org/complianceline. If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.