1 Nov
2012
1 Nov
'12
1:10 p.m.
save it as a patch On Thu, 1 Nov 2012, octavian lie wrote:
Thank you, Bruce. Is seems that the cut works well in tksurfer, however I am unable to save the cut surface, if I use save or save as, it saves the original (whole) surface. What should I do? Octavian.
On Thu, Nov 1, 2012 at 11:49 AM, Bruce Fischl fischl@nmr.mgh.harvard.edu wrote: the easiest thing would be to copy it into surface as lh.bem then run tksurfer on it On Thu, 1 Nov 2012, octavian lie wrote:
Thank you for your quick prompt, how do I pull the inner skull surface into tksurfer, given it is in /bem and not in /surf, and does not have a lh or rh option? Octavian On Thu, Nov 1, 2012 at 11:41 AM, Bruce Fischl <fischl@nmr.mgh.harvard.edu> wrote: Hi Octavian sure, define a sagittal cutting plane in tksurfer, or in matlab set ripflag=1 for all vertices with the x coord > 0 (or < 0) cheers Bruce On Thu, 1 Nov 2012, octavian lie wrote: Dear all, Is there a way to crop a surface in FS, freeview or matlab? I have the inner_skull_surface in BEM folder, and I want to see just the right half, akin to cropping along the A (RAS) axis from the left. This is in order to visualize the inside of the surface with some electrode applications. Also, if the surface can be created in MNE just on the right side that will solve it. Help much appreciated, Octavian Lie. The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.