you need the white surfae I believe and the inflated. Do you have those?
On Mon, 2 May 2016, Muhammad Razib wrote:
Dear Fischl, Thank you so much for your reply. I don't have all the files that have been created by recon-all. For the surfaces I just have the .pial files. Is there a way to generate .sphere files from .pial files? Or we need the original volume files and then run recon-all to reconstruct them?
Thanks
On Mon, May 2, 2016 at 8:33 AM, Bruce Fischl fischl@nmr.mgh.harvard.edu wrote: Hi Muhammad
are you using recon-all? It should create everything, including both pial and sphere. I think the spheres are create earlier in the recon process than the pial these days cheers Bruce On Mon, 2 May 2016, Muhammad Razib wrote: Hi, I have some (freesurfer generated) pial surfaces, but I don't have the sphere surfaces of these. Is there a command in freesurfer to generate .sphere file from .pial file? --- Muhammad Razib
Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
-- Muhammad Razib