I mean if you look at the lh.orig.nofix (or the lh.orig since the topology fixing didn't finish) do you see the two hemis attached? Are there large chunks of skull included in the surface? Is the cerebellum attached? Whatever is wrong is not subtle
On Fri, 19 Apr 2013, Claudia Dacquino wrote:
Hi Bruce,I did check, the only problem that I could see is that in some slides ctrl pts are out of wm. What you mean with something dramatically wrong? Cheers, Claudia
2013/4/18 Bruce Fischl fischl@nmr.mgh.harvard.edu Hi Claudia
that defect is bigger than more cortical surfaces so something is dramatically wrong. Did you check any of the outputs (wm.mgz, filled.mgz, lh.orig, etc...)? cheers Bruce On Thu, 18 Apr 2013, Claudia Dacquino wrote: Hi freesurfer, my autorecon2-cp after ctrl pts edits exited with this error message: CORRECTING DEFECT 0 (vertices=176788, convex hull=8149) Excessive topologic defect encountered: could not allocate -776253752 edges for retessellation Cannot allocate memory Could anyone help me with this, please? Thanks to all. Cheers ClaudiaThe information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.