The number of vertices match between the lh.sphere.reg and lh.pial. All of the timestamps are the same as well. I just tried this with v5.3 as well and the problem is the same. Thank you for helping with this!
-Matt Defenderfer
Matthew K. Defenderfer B.S. | Graduate Research Assistant
Graduate Biomedical Sciences | Neuroscience
UAB | The University of Alabama at Birmingham
Laboratory of Kristina Visscher, PhD
Department of Neurobiology
CIRC 111 | C: (865) 805-6389
________________________________ From: freesurfer-bounces@nmr.mgh.harvard.edu freesurfer-bounces@nmr.mgh.harvard.edu on behalf of Bruce Fischl fischl@nmr.mgh.harvard.edu Sent: Wednesday, December 13, 2017 4:16:03 PM To: Freesurfer support list Subject: Re: [Freesurfer] mri_surf2surf on edited subjects
Hi Matt
can you run mris_euler_number on that subject's lh.sphere.reg and see if it has the same number of vertices as the lh.pial for example? Or check timestamps. If it was not recreated after your editing you will need to rerun part of recon-all
cheers Bruce
On Wed, 13 Dec 2017, Defenderfer, Matthew K wrote:
Hi all,
I am trying to transfer a surface file from fsaverage_sym space to a recently edited individual subject's hemisphere. I previously ran recon-all on the subject and then edited the wm, brainmask, etc. to fix some defects I had found. Before the edits, I could transfer the surface and load it on the subject's hemisphere as an overlay perfectly fine. After editing and rerunning the subject through recon-all and the xhemi pipeline, I tried to transfer and load the overlay again using the following command, same as originally:
mri_surf2surf --srcsubject fsaverage_sym --srcsurfreg sphere.reg --trgsubject subj001 --trgsurfreg fsaverage_sym.sphere.reg --hemi lh --sval template.sym.mgh --tval subj001/surf/template.sym.mgh
The command completes, but the resulting overlay does not have the same number of vertices as the surface. It does however, have the same number of vertices as the original surface from before rerunning the recon-all command. So it seems like it's still transferring the overlay to original surface. My SUBJECTS_DIR does not have the subjects' original recon-all data in it either, just the data from the edited recon-all. Any help on this would be appreciated. Thank you!
-Matt Defenderfer
Matthew K. Defenderfer B.S. | Graduate Research Assistant
Graduate Biomedical Sciences | Neuroscience
UAB | The University of Alabama at Birmingham
Laboratory of Kristina Visscher, PhD
Department of Neurobiology
CIRC 111 | C: (865) 805-6389