Hi, FreeSurfer experts
I am posting it here again since I still have not had the issue solved. Basically, I find that white matter surface does not follow the wm.mgz file (see the attached files). It is strange that such a problem is only located at the precentral gyrus. I checked the white matter original surface and the inflated surface and they look fine. I also went through wm.mgz slice by slice to see if there is abrupt gradient between slices and it doe not seem to have that either. I also checked the orig.nofix with defects_label overlaied as suggested by Bruce and I do not see red marks close to the region (see attached file). So I wonder if anyone would help on solving the issue.
Many thanks in advance
Leon
----- Forwarded Message ----- From: Bruce Fischl fischl@nmr.mgh.harvard.edu To: Leon leonado78@yahoo.com Sent: Friday, May 25, 2012 11:23 AM Subject: Re: [Freesurfer] wm surface does not follow wm.mgz
Hi Leon
can you cc the list so others can answer? I don't have any experience with monkey recons so I'm not going to be able to be all that helpful. Check the filled.mgz and see if the surface follows it, and if so we'll have to figure out why that region is being turned on in the filled cheers Bruce
On Fri, 25 May 2012, Leon wrote:
Hi, Bruce
I checked the orig.nofix and do not see any obvious defect there (see the attached file). Do you have any suggestions on how I should check the defects other than visual check? I loaded the defect_label and there is no red label near this region.
Thank you! Leon
From: Bruce Fischl fischl@nmr.mgh.harvard.edu To: Leon leonado78@yahoo.com Sent: Wednesday, May 23, 2012 7:28 PM Subject: Re: [Freesurfer] wm surface does not follow wm.mgz
That almost certainly means there is a topological defect there. Check the orig.nofix
Cheers Bruce
On May 23, 2012, at 2:49 PM, Leon leonado78@yahoo.com wrote:
Hi, FreeSurfer experts
I have seen similar posts before but did not think that I could solve the issue based on the answers from the previous posts. So I am posting it here again. Basically, I find that white matter surface does not follow the wm.mgz file (see the attached file). It is strange that such problem is only located at the precentral gyrus. I checked the white matter original surface and the inflated surface and they look fine. I also went through wm.mgz slice by slice to see if there is abrupt gradient between slices and it doe not seem to have that either. So I wonder if anyone would help on solving this issue.
Thanks in advance! Leon
<RightPreCentralGyri.jpg>
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
