Hello,i am a new user of freeesurfer.i am so sorry for nor helping you.Can you do me a favor?Please show me how to use freesurfer mail list.Thanks a lot.Just give me a link to freesurfer mail list ,for example.i will highly appreciate it if you show me more in deail!i am looking forward for your early reply at your convenience.
2015-10-08 16:40 GMT+08:00 Maya De Belder Maya.DeBelder@ugent.be:
Hi,
I’m stuck with the following problem: I can’t start up the VirtualBox for Freesurfer5.3 because of a memory problem. I put 12GB of patient data on the disk en ran two subjects successfully through Freesurfer. However, I closed the VirtualBox and don’t seem to be able to restart it. My question is:
- Is there a way to get around this? Is there a possibility to increase de
memory size?
- How much data is constructed by Freesurferprocesses when you run an
MPRAGE through the processes?
- Assume I don’t mind re-running those two subjects and will completely
re-install the Virtualbox: is there a possibility to increase the disk size?
- The data I have for 1 single patient will always be +- 500 MB, my study
contains over 100 subjects. Is there a way to run the analysis in Virtualbox that way, or is an alternative suggested?
Thanks in advance for the feedback, Maya De Belder
PhD Student Ghent University Department of Experimental Psychology Henri Dunantlaan 2 B-9000 Ghent, Belgium +32 9 264 64 03
Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.