You need to swap the values of the hpf and lpf. The way you have it, you are essentially filtering out everything above .01 Hz, which probably leaves almost no signal
On 1/3/18 3:00 PM, stdp82@virgilio.it wrote:
mkanalysis-sess -analysis fc.lhamgseed.surf.lh -surface fsaverage lh -fwhm 6 -notask -taskreg L_Amygdala.dat 1 -nuisreg vcsf.dat 5 -nuisreg wm.dat 5 -polyfit 5 -nskip 4 -mcextreg -fsd rest -TR 3 -per-run -hpf 0.1 -lpf 0.01
Thanks
Il 31 dicembre 2017 alle 22.34 Douglas Greve greve@nmr.mgh.harvard.edu ha scritto:
What is your mkanalysis-sess command line?
On 12/28/17 8:53 AM, stdp82@virgilio.it mailto:stdp82@virgilio.it wrote:
Running the "selxavg3-sess -s" command line in FS-FAST for seed-based functional connectivity analysis
the following errors occurred:
Temporally filtering
Error using chol
Matrix must be positive definite.
Error in fast_selxavg3b (line 947)
Wseg = inv(chol(toeplitz(acfrun))');
Thanks
Stefano
Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu mailto:Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.