Hi Joakim,
I think you can remove entirely the -t option. The area will be one of the fields in the table, regardless of this option, as it depends on the mesh that is used to derive all other measurements except thickness. If you specify an ?h.area file with -t, it will instead output incorrect results for thickness, as it will treat the given area file as if it were thickness, and not really changing the areas reported in the table.
Hope this helps!
All the best,
Anderson
On 05/27/2011 03:41 PM, Joakim Vinberg wrote:
Hi everybody,
I just want to make sure I'm using the correct the correct syntax for running mris_anatomical_stats for examining cortical area. Based on the QDec Group Analysis page, my I was running the following command to examine cortical thickness:
mris_anatomical_stats -l rh.test.label -t rh.thickness -b -f subject/stats/rh.test.stats subject rh
To adjust this for cortical area, would I just replace the rh.thickness above with rh.area, or remove it entirely?
Thanks in advance!
Joakim
Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.