Try clicking the inflated surface button afterwards

On Dec 2, 2010, at 8:16 AM, Vadim Axel axel.vadim@gmail.com wrote:

Thanks, Bruce. Though "clear cuts" button indeed works fine with 3d patches, the procedure results in complete mess with flattened patches...

On Thu, Dec 2, 2010 at 3:00 PM, Bruce Fischl fischl@nmr.mgh.harvard.edu wrote: Hi Vadim

yes, click the "clear cuts" button (or menu item, I can't remember) Bruce

On Thu, 2 Dec 2010, Vadim Axel wrote:

Hi,

After loading, for example, flattened patch I would like to go back to a standard, inflated brain without patch while I preserve all my overlays. Is it possible?

Thanks, Vadim

The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.