It should automatically detect that this was a retinotopy analysis and then load the polar and eccen. Was this configured as a retinotopy analysis? Can you send me the

$ANALYSIS_PHASE/analysis.info file?

doug

On 12/05/2012 04:12 PM, Julia Foecker wrote:

Hi Doug,

I tried now several ways to get the maps on the surface:

1. When I am deleting -retinotopy flag and type in:

...

...

tksurfer-sess -debug -s $SESSIONNAME -hemi lh -d $SESSIONDIRECTORY -analysis $ANALYSIS_PHASE

I got the message:no contrast has been specified

(I do not have any contrasts in the analysis, just use polar angle maps)

2. I tried to use the commands on the website you referred to, but I do not

have -surface in the preproc-sess (see attached) The other commands depend on this preproc-sess command.

3. I tried the following command

paint-sess -s $SESSIONNAME -d $SESSIONDIRECTORY -analysis $ANALYSIS_PHASE

and I got the errors listed below...

I am not sure how to procede. Would you have any further suggestions? Many thanks, Julia

Thanks, Julia