Hi,

I am interested in looking at between-group differences in in LGI on Qdec (I will look at surface area as well later). I have a question regarding the smoothing stage. My recon-all for all subjects has completed, and I have LGI values for each subject. For smoothing, I was going to run the following command line: Recon-all –s <subjid> -qcache

However, I saw in an archive post someone mentioning running the following line instead: recon-all -s <subjid> -qcache -measure pial_lgi

Will you please tell me which command line I have to run?

Thanks so much,

Avi

CONFIDENTIALITY NOTICE: This e-mail message, including any attachments, is for the sole use of the intended recipient(s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient, please contact the sender by reply e-mail and destroy all copies of the original message.

AVIS DE CONFIDENTIALITÉ : Ce message électronique, ainsi que tout fichier qui y est joint, est reserve à l'usage exclusif du destinataire visé et peut contenir des renseignements confidentiels et privilégiés. Toute lecture, utilisation, divulgation ou distribution non autorisée est interdite. Si vous n'êtes pas le destinataire visé, veuillez en aviser l'expéditeur par retour de courriel et détruire toutes les copies du message original.