Dear Louis,
Thank you very much!
Sincerely, Ye
On Thu, Jul 11, 2013 at 4:12 PM, Louis Nicholas Vinke < vinke@nmr.mgh.harvard.edu> wrote:
Hi Ye, Is the dura in question affecting the surfaces? If so you can delete the dura, add control points and then run command 4 below. You don't need to rerun autorecon1. -Louis
On Thu, 11 Jul 2013, ye tian wrote:
Dear freesurfers,
I have a subject for which I need to delete some dura in brainmask.mgz and to add some control points. I wonder whether I can do it the following way (to save time):
- Manually delete extra dura in brainmask.mgz
- recon-all autoreon1
- Add control points
- recon-all -autoreon2-cp -autorecon3
Thank you very much!
Sincerely, Ye
The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/**compliancelinehttp://www.partners.org/complianceline. If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.