Doug-
I'm really sorry to keep pestering you about this but I just can't seem to get this to work. See my replies below:
On 09/30/2016 02:00 PM, Douglas N Greve wrote:
First, bring up the ROI on the volume along with the surface in the volume. You can do this with FreeView. Make sure that the ROI intersects the surface.
Yes, this looks fine
Then run mri_vol2surf so sample the binary ROI volume onto the surface.
This is what I ran: mri_vol2surf --src $SUBJECTS_DIR/subA/tmpdir/roi.mgz \ --out $SUBJECTS_DIR/subA/tmpdir/rh.roiS.mgh \ --regheader subA --hemi rh --surf pial
You can view the ROI on the surface by loading it as an overlay.
This is a volume or a surface now? Is it just a volume resampled to the surface space? I can't get it to load in freeview as a surface (it just crashes), and it doesn't look like anything as an overlay.
Then run mri_cor2label using the surface-sampled ROI as input and specifying --surf (see the --help) to make this a surface-based label. You can also view this label in the surface in freeview. Finally, run mri_label2label using the --regmethod surface
________________________________ Notice: This UI Health Care e-mail (including attachments) is covered by the Electronic Communications Privacy Act, 18 U.S.C. 2510-2521 and is intended only for the use of the individual or entity to which it is addressed, and may contain information that is privileged, confidential, and exempt from disclosure under applicable law. If you are not the intended recipient, any dissemination, distribution or copying of this communication is strictly prohibited. If you have received this communication in error, please notify the sender immediately and delete or destroy all copies of the original message and attachments thereto. Email sent to or from UI Health Care may be retained as required by law or regulation. Thank you. ________________________________