Dear Richard,
Yesterday I performed single subject analysis with -use-gpu flag and allowed to take its own time to complete. It's get completed within 5.8 hrs. Yes you are correct. I should not interrupt before a final output. And I have realized that gpu and cpu outputs on the terminal are not similar. Thank you for your feedback.
I have one question. When use -use-gpu flag, can I use -itkthreads 8 or -use openmp 8 flag?
Thanks Ramesh
On Tue, May 23, 2017 at 1:51 AM, R Edgar freesurfer.rge@gmail.com wrote:
On 22 May 2017 at 07:39, Ramesh Babu mgrameshbabu2013@gmail.com wrote:
The following last line get repeated same way except (%) in the second
line
pasted below. On the third line "Did not call MRIsetResolution", is it
error
or normal process? Since repeated many times I thought there is some
error.
PutOnGPU: Did not reset gca in dst 0270: dt=9.072001, rms=0.557 (0.021%), neg=0, invalid=762 LabelTerm: Did not call MRIsetResolution
That's completely normal - it was sort of an aide-memoire for myself. Should things start messing up in interesting ways, that might be something to go and check (at the time I did the port, it was a no-op for the command I was running). So long as the nnn: dt=.... lines are popping out OK, it's running.
Richard _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.