Re: [Freesurfer] Tracula error ? set: Variable name must begin with a letter

Hi Anastasia,

You were right ! I fixed ncpts = 5 for all 18 tracts and th preprocessing step runs.

Thanks, Matthieu

2013/12/11 Anastasia Yendiki ayendiki@nmr.mgh.harvard.edu

Hi Matthieu - In 5.1 the number of control points (ncpts) was only one number, the same for all 18 tracts. Not sure if this is what's causing the error.

a.y

On Wed, 11 Dec 2013, Matthieu Vanhoutte wrote:

Hi Anastasia,

...

I have taken this original file in "FSDIR5.1/bin/dmrirc.example" and modify into "dmrirc.tutorial", so this is meant for use with the version of tracula that's in 5.1 ?

I will switch to the last version, but before this I'd like to succeed launching tracula on 5.1...

Best,

Matthieu

2013/12/11 Anastasia Yendiki ayendiki@nmr.mgh.harvard.edu

  Hi Matthieu - This sample dmrirc file is meant for use with the
  version of tracula that's in 5.3, not 5.1. I would strongly
  recommend switching to that version of tracula anyway, due to
  improvements in performance and speed.

  a.y

  On Wed, 11 Dec 2013, Matthieu Vanhoutte wrote:

        Hello experts,

        I am running the first pre-processing
        step in Tracula on FS 5.1 and come across the
        error:

        set: Variable name must begin with a
        letter

        I have attached my dmrirc file. Did I make a mistake
        in this file?
        Best regards,

        Matthieu

The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.