there a few notes on flattening at the end of the recon-all help text. see the end of: https://surfer.nmr.mgh.harvard.edu/fswiki/recon-all i don't know if it will help with your problem though.
On Wed, 2006-05-31 at 08:38 -0700, adam walczak wrote:
It did something, but I only made one cut and it produced something not looking correctly...it also crashes when I try to load the ROI that I want to overlay. That is the reason I am making the flattened image anyway.
adam
--- Bruce Fischl fischl@nmr.mgh.harvard.edu wrote:
that sounds about right depending on the size of the patch. Did it work?
On Wed, 31 May 2006, adam walczak wrote:
about how long should the flattening process take?
mris_flatten took about nine hours when I tried it yesterday.
adam
--- Bruce Fischl fischl@nmr.mgh.harvard.edu
wrote:
use tksurfer.
On Wed, 31 May 2006, adam walczak wrote:
Hello,
I was searching through the wiki and ran across
a
page
that said to use csurf to make full surface cuts
in
order to ultimately create flattened surfaces.
But
while perusing the support archives, it was said
that
csurf is no longer supported. Is this true?
How
then
do you make the full surface cuts needed to
create
the
flattened surfaces?
Thanks
Adam
adam
Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam
protection around
http://mail.yahoo.com _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
adam
Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam
protection around
adam
Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer