Hi Freesurfer experts,
I found the answer to my previous question on FreeSurfer Wiki regarding pre-smoothing command line for LGI ( I am interested in looking at between-group differences in vertwex-wise LGI values).
I am now aware that the following command line must be used:
recon-all -s <subjid> -qcache -measure pial_lgi
However, if I also want to look at surface area differences between groups later on, is using the above pre-smoothing command line correct? OR do I have to use the following command line considering that I Am not only looking at LGI values : recon-all -s <subjid> -qcache
Would really appreciate your advice,
Thanks,
Avi
CONFIDENTIALITY NOTICE: This e-mail message, including any attachments, is for the sole use of the intended recipient(s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient, please contact the sender by reply e-mail and destroy all copies of the original message.
AVIS DE CONFIDENTIALITÉ : Ce message électronique, ainsi que tout fichier qui y est joint, est reserve à l'usage exclusif du destinataire visé et peut contenir des renseignements confidentiels et privilégiés. Toute lecture, utilisation, divulgation ou distribution non autorisée est interdite. Si vous n'êtes pas le destinataire visé, veuillez en aviser l'expéditeur par retour de courriel et détruire toutes les copies du message original.