Thanks bruce for your response. Since there is no documentation, how can i use it because I seen trends on the forum where it was suggested to use reposition surface ( e.g. https://mail.nmr.mgh.harvard.edu/pipermail/freesurfer/2012-October/026117.ht...). Use = directions and parameters to input. Thanks Best, Paul
On Tue, Jan 10, 2017 at 12:42 PM, Bruce Fischl fischl@nmr.mgh.harvard.edu wrote:
Hi Paul
sorry, this is something that Ruopeng put together for me to mess around with - there isn't any documentation
cheers Bruce
On Tue, 10 Jan 2017, miracle ozzoude wrote:
Hello Freesurfer, I would like to learn how to use the reposition surface
tool in freeview. Specifically, what parameters to enter in the gui (see screenshots). Is there any documentation on how to use it if not, can someone with experience work me through it. Thank you. best, Paul
Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.