I see thank you, and what would I use as the measure? Because for asegstats2table I chose between volume and mean correct? Sorry a bit new at this.
Tara
----- Original Message -----
From: "Douglas N Greve" greve@nmr.mgh.harvard.edu
To: freesurfer@nmr.mgh.harvard.edu
Sent: Friday, November 8, 2013 1:00:18 PM
Subject: Re: [Freesurfer] sulci depth in table
If you are using mri_segstats then you should use asegstats2table
doug
On 11/08/2013 11:35 AM, Tara Ann Miskovich wrote:
Hello,
I am extracting sulci depth using the following
mri_segstats --annot ${subject} lh aparc --sum lh.sulc.sum --i surf/lh.sulc
Do you know how I could put this into aparcstats2table?
Thank you,
Tara
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
--
Douglas N. Greve, Ph.D.
MGH-NMR Center
greve@nmr.mgh.harvard.edu
Phone Number: 617-724-2358
Fax: 617-726-7422
Bugs: surfer.nmr.mgh.harvard.edu/fswiki/BugReporting
FileDrop:
https://gate.nmr.mgh.harvard.edu/filedrop2
www.nmr.mgh.harvard.edu/facility/filedrop/index.html
Outgoing: ftp://surfer.nmr.mgh.harvard.edu/transfer/outgoing/flat/greve/
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
