The Volumes module in 3D slicer (v3) will load mgz files. You can use the Model Maker module to create models of your structures using the FreeSurfer label codes.
_________________________ Jeffrey J. Dewey Center for Neurological Imaging Brigham and Women's Hospital 1249 Boylston St, 3rd Floor Boston, MA 02215 jdewey@bwh.harvard.edu
On Mar 17, 2009, at 3:26 PM, Alexa Nardelli wrote:
Hi,
I have used FreeSurfer volumetrics to obtain various volumes of some subcortical structures. I would like to obtain a 3D image of each of these subcortical structures. I have tried importing the volumes into Matlab, however Matlab doesn't recognize the mgz file. Any suggestions on how I could go about doing this?
Thanks,
Alexa _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.